The DA35 Autocan piston pump is used to pump highly viscous media from small containers. Simply remove the lid from the can and place it under the plunger pump. Then slide the pump into the can. The entire medium below the plunger is pushed out except for a small amount of residue and conveyed, for example, to a high-pressure valve DV-5370, which can be equipped with a handle bracket (optional).
The valve is controlled by the DC1060 dispenser and a switch on the handle bracket. The system is suitable for manual or time-controlled dosing and excludes dripping.
With an appropriate fitting, cartridges can also be filled!

We adapt the follower plate exactly to your container. Please indicate the inside diameter when ordering.

We would be happy to advise you.

Characteristics:

     Low amount of waste
     No contamination of the material
     No decanting of the material required

 

TECHNICAL SPECIFICATIONS:

Maximum liquid outlet pressure: 60 bar
Main air supply pressure range: 2.4-7.0 bar
Maximum viscosity of the medium: 300,000 mPas
Volume per stroke: 5.0 cm3
Recommended pump speed for continuous use: 40 cpm
Maximum recommended pump speed: 60 cpm
Stroke: 19mm
Air Inlet Size: 1/4 / Ø6mm
Fluid Outlet Size: 1/4 npt(f )
Material of wetted parts: 304 and 17-4 pH stainless steel; PTFE, Viton, PEEK
Noise pressure level at 7 bar, 40 cpm: 64.12 dB(A)
Sound power level at 7 bar, 40 cpm: 70.84 dB(A)