You are using an unsupported browser - the site is running in restricted mode. For proper operation of the site, use, for example, mozilla Firefox, google Chrome, MS Edge and the like.

You are using an unsupported browser - the site is running in restricted mode. For proper operation of the site, use, for example, mozilla Firefox, google Chrome, MS Edge and the like.

Exhaust unit for HR-10 oven

Exhaust unit for HR-10 oven

Code FE-10
Availability In stock 1 pcs

Extraction unit for reflow oven HR-10 and HR-10-DO.
It sucks the soldering fumes only after the melting is finished.
Due to the forced air flow in the oven, the cooling time is reduced.

 

The suction unit includes a fan and a switching unit.
Connects to prepared HR-10 / HR-10-DO oven connectors.
The oven control system controls the fan speed. During preheating and re-melting, the speed is minimal to prevent cold air being drawn into the furnace. cycle. Just after finishing the rewind before the door is opened, the fan speed is increased to a maximum for complete exhausting after soldering. The fan speed is again reduced to a minimum after the furnace has cooled to ground temperature.
The outlet from the suction unit can be connected either to the central suction inlet or to a separate filter unit.

Accessory Contents:
Power supply cable 230V / 50Hz - male for direct connection to HR-10 / HR-10-DO
Signal cable - fan speed control from the furnace control board
Inlet hose 1 m with a diameter of 50mm
Outlet hose 1 m with a diameter of 56 mm.
Never shorten these hoses for sufficient cooling of the exhaust oven!

Code: HR-10-DO
Reflow oven HR-10 motorized
In stock 5 pcs
Code: HR-10
Reflow oven HR-10 manually opened
In stock 1 pcs
Code: HR-10-DO-N2
Reflow oven motorised with N2
The operator and supplier for ESDshop.eu is ELPRO, s.r.o.